Prepare the bed plate
This is the bed plate: 
Add the four feet in the kit to form a square. ...
Mounting Z-Motor to the bed-plate Insert two M5x65 bolts into the flexible damper 
And secure it to the motor as shown: ...
Insert this part into every corner except for the one with the stepper motor. Note: Before continuing check that the 6 bolts for the electronic ...
Now, on this step it is important that the four large case plates are mounted in the correct position. - Front
- Back
- Left
...
You will now need 4 of the 5 triangular corner brackets. Insert t them into the slots on every corner 
Important: Be ...
Attach the motor coupling to the Z motor. Be sure that it sits straight on it, otherwise it will create a lot of load to ...
Grab the prepared ~33cm threaded rod with two pulleys for Z drive. 
Push down the threaded rod and adjust ...
Grab the prepared ~40cm threaded rods for Z drive. The one with two pulleys will go to the back right side. The ones with ...
Important: Check that the part on the top corner is aligned the same way as the one on the bottom plate. See red marking for ...
This paragraph is currently missing documentation and/or pictures.
