Prepare the bed plate
This is the bed plate: 
Add the four feet in the kit to form a square. ...
Mounting Z-Motor to the bed-plate Insert two M5x65 bolts into the flexible damper 
And secure it to the motor as shown: ...
Insert this part into every corner except for the one with the stepper motor. Note: Before continuing check that the 6 bolts for the electronic ...
The major change since 1.0 is that the corner brackets have to be installed while mounting the frame. On this step it is important ...
Attach the motor coupling to the Z motor. Be sure that it sits straight on it, otherwise it will create a lot of load to ...
Grab the prepared ~33cm threaded rod with two pulleys for Z drive. 
Push down the threaded rod and adjust ...
Grab the prepared ~40cm threaded rods for Z drive. The one with two pulleys will go to the back right side. The ones with ...
Note
The part shown here: 
now looks like this: 
Inserting the belts
Insert the belts like this: 
Then ...
This paragraph is currently missing documentation and/or pictures.
