Y drive peparations

1. Bearing support

You will need these parts:

Those will hold one 608 ball bearing each and will avoid ...

You need the 500mm threaded rod. Push it through a bit to the 8mm hole on the right side

...

Insert one of the two 500mm straight bars and slide in the x motor carriage.

Don't worry about it hanging around like ...

Insert two 400mm straight bards to the corresponding slots on both X drive & idler. Insert the X toolhead holder as shown below.

...

You will need the slightly longer (~93cm) belt for X. This part is used for clamping the belt:

Clamp ...