Y drive preparations

1. Bearing support You will need two of these:

Those will hold one 608 ball bearing each and ...

You need the two short pieces of threaded rod. Each piece goes through one of the y idler supports. The images below are

...

Insert one of the two 500mm straight bars and slide in the x motor carriage.

Don't worry about it hanging around like ...

Insert two 400mm straight bards to the corresponding slots on both X drive & idler. Insert the X toolhead holder as shown below.

...

X belt

You will need the slightly longer (~93cm) belt for X. This part is used for clamping the belt:

Clamp ...